Ok my winter project is fixing the floor pan and frame rail rust on may car and rewiring the whole car becasue the PO screwed the harness up big time, below you will see random pics of my progress and my car, these will change from time to time and the whole project will get its own page when i am finally done. This will actually be two pages one for wiring and one for rust.  Enjoy!
The pasenger side of the motor, this motor is dirty but i plan on cleaning it, here i have already removed the air conditioning stuff. 
The driver side of the motor/transmition, dirty but it will be cleaned.  I am going to swap a early balance tube on to get rid of the emissions stuff, also going to remove the smog pump because it doesn't work anyways.
Picture of the removed dash, don't know if you can see the wiring well enough to see that the PO rewired most of the dash using his fingers and electrical tape.  The fog light wires are also fried and the combo switch has been rewired. 
The empty engine bay, what else can i say?
Picture of the rusted out floor on the driver side, it is worse then the passenger side.  You can see the garage floor through the car floor just in front of the seat support, no wonder i was getting wet whenever it rained!
The intirior is removed except for the heater and aircondioning.  This stuff is out now but i dont have any new pictures yet, the AC is not going back in but the heater is.
Hosted by www.Geocities.ws

1