HELLO

How To Build A Nuclear Reactor (With Version 7.0)

 

Firstly, make some Earth, and put some Uranium Ore underground. Make sure borders are turned on in Burning Sand.

Next, build a container using Reactor just how it is in the picture. Make sure the bottom  section is not too tall.

Then, draw some Drill next to the reactor, making sure it either touches or is slightly within the wall of the reactor. A hole will be drilled to the Ore, which will then start coming to the surface.
While the hole is being drilled, make some Heat Pad and Generator like in the image.

 
When the uranium pipe that has been drilled is completely finished (it MUST be totally solid to prevent radiation leaks), make some Uranium tap like in the image. It's important you make it like this to prevent any leaks. Then, above the heat pad, make some water to be boiled.
A working nuclear reactor:

As time goes on, the reactor will wear away, and will need replacing. The uranium tap will need replacing the most. If you design it well enough, the tap can last longer than the reactor walls however. See the next image for the results of a radiation leak...
Be careful...
Hosted by www.Geocities.ws

1