1. Take off your front bumper cover: Use the flathead to pop out the 7 plastic snap connectors across the top of the grill (when you open the hood and look down). Next use the phillips screwdriver to remove the philips screws by the wheel wells (one on each side) and one phillips screw under the lower intake resonator. Last, take the wrench and take out the two 10mm bolts under the bumper chin. Put all these screws and bolts in a safe place. Remove the bumper.

2. Carefully unplug your headlight and turn signals bulbs and put them aside, unscrew any headlamp screws and take out your headlamps.

3. Pick a headlamp and take a heat gun on low setting (or a blowdryer on high setting) and melt the silicone around the casing. Use a flathead to prop it open and guide the heat along the entire casing.

4. When it is open, remove the three screws that hold the orange cup and long thin reflector in place.

5. Wipe everything clean and put casing back together. Use the silicone and carefully seal back the casing tightly. *****It will leak or fog up during rain or car washes if you do not do this part correctly!!***** Do not skimp on the silicone, make sure it covers the entire casing.

6. Let dry before putting it back in the car.

7. Repeat for other headlamp.

8. Put bumper cover back on.

***At this time you can also replace your stock bulbs with superwhite turn signals (In almost fifty states it is legal to have amber, yellow or WHITE front turn signals, but check your state's statutes for any modification of this law.)

Good luck!