*Both of these firecrackers are extremely illegal. I and the staff at Our Page is Better Than Yours will not be held responsible or accountable for any mishaps or law entanglements that may occur while constructing or detonating these explosive devises. Either of these devices can easily sever your hand or blind you permanently. DO NOT construct these devices unless you know what you are doing and you are licenced to do so. You have been warned.*
Pop lid Cherry bomb (puck bomb)
You need:
gunpowder/or powder out of other fireworks
fuse/longer the better
two pop lids
drill
one 1/8" drill bit
one 1/4" drill bit
thin cardboard
glue gun
duct tap
First drill a 1/8" hole in the middle of one cap and a 1/4" hole in the other. Take the fuse and stick it in the 1/8" hole about �" (make sure the �" part of the fuse is stuck in on the sides where the treads are.) Glue on both sides with glue gun NOTE: super glue ruins fuses) On the top part of the cap, glue the fuse so that it is laying down flat against the top. Now take some tape and tape the open ends together flush around the middle. Now you will fill the container with gunpowder/other through the 1/4" hole. do not pack the powder. get as much in as you can with out packing. now take the cardboard and securely plug up the hole. now you will have to wrap in duct tape, more tape the better. put a lot of tape over the holes, this is why we glued the fuse sideways, so that it would stick out the side under the tape. Now light and watch explosion. be sure you are at least 35' away when it goes off. You can also use only one cap, just cover the open end with a 1/8" thick p iece of wood that is the same diameter as the cap and tape over, much easier to fill and make and you still get a kick ass bang.
Black Limon Bomb
You need:
A small to medium size clear fishing bobber.
gunpowder/other
drill
1/8" bit
1/4" bit
duct tape
black thread
fast dry epoxy
fuse about 5" for safety
glue gun
thin cardboard
First glue the thing in the middle snug with epoxy. let dry. now drill a 1/8" hole in the side and insert fuse, glue sideways with glue gun. drill hole in other side with 1/4" bit and fill all the way up with gunpowder/other. Plug hole with cardboard. Now run a few layers of tape around the whole thing, be sure to stick the fuse out sideways of the hole and to put extra tape over the holes and to put extra tape over the pointy ends. Now take the black thread and entirely cover the bobber with it until you can�t see tape anymore. Place glue on thread to secure it. when it is complete it should look like a small black lemon with a fuse sticking out the pointy side. If ya want you can add more tape after words, I don�t know if it will help or not, but it should make a more violent explosion.