Home after step 1 as a niqab
Products step 2
step 1
How it looks after step 2 from the side with panel down. Close up of side
How it looks as a niqab,just after step 2 simply pull the panel up under the eyes.
Step 2: wrap the right panel to the side and snap or pin to the headband. Step 3: Wrap remaining panel to the side and pin with a stick pin or use the snap installed.
How it looks after step one with sides hanging down.
Step 1, tie behind the nape of the neck to secure the hijab.
Below are step by step pictures on how to do the tie & wraps.
-Grab hijab and place op top of head
- Grab the tie backs and pull in back of head
- Tie securely  grab hanging panel and pull to the side then snap or pin
- To wear as a hijab simply pull the panel down without unsnapping the side.
Troubleshooting:

If the hijab is on and the niqab part looks crooked to you:  
simply slide the band on the forehead to the right or left and it will be aligned just above your ears then snap it.

If you put it on and it looks inside out:
Try turning it over :) the inside part should be placed on top of the head then you grab the tie backs and tie them behind the head.

When you walk it seems to fly open on the chest area:
You may use the average safety pin, hijab pin or brooch to secure the hijab in place or ask us to add a snap in your desired place for additional cost of 1.00.

The hijab just isn't long enough for your taste:
Try sending us your measurements from where you want it to rest on top of the head to where you want the point to fall in the rear. If it does not require much more fabric we will extend the length on your future orders ( at no additional charge)  if you request in advance.
  
If it requires more fabric, we will email you the additional cost and send you a customized invoice when you make a decision.   In addition... we sell thigh length khimar version of this item for $30.00, you can now view it on
this page..contact us to place an order
Hosted by www.Geocities.ws

1