Clippers
X-acto knife w/ 11 blade
Milliput or some other putty
Sand paper of some sort
Close combat weapon
Helmetless Guardian head
Step Two: Make an incission on the wing/jet thing up to the seat area. See picture one.
Step Three: (Optional) File/cut the front of the shurken catipult. This will make it look a bit more like the old style jetbikes.
Step Four: Get one of the jets that where cut and glue under the jetbike (underneath the seat). Cut off the wing of the jet if it has not been done yet. Get putty out and put it around the area where the single jet is to make it look attached to the bike still. See picture two.
Step Five: (Optional) If you are going to be using the classic Harlequin cover thing, cut away the area the piece of plastic that is made for holding the plastic cover. Putty maybe needed.
-===========================================-
Making Your Own Cover
Step One: Get putty out and make the outline of the mouth.
Step Two: Cover the remaining area of the cover aside from the mouth.
Step Three: Make nose, and eyebrows. You can make nostrils, but not too big.
Step Four: Cut away where you want the eyes to go.
See pic 2.
Voila!
Making Your Own Rider (the way that I did mine)
Step One: Get out rider that comes with the jetbike. Cut away head and replace with the helmetless head from the Guardian box set
Step Two: (Optional) Cut the right (or left) leg up to about the knee area. Repositon it so when the rider is on the bike the right (or left) leg will be off of the pedal.
Step Three: Cut right (or left) hand of and repostion to area that is desired. Glue on the close combat weapon that you have chosen to use.
Voila!
