1. Build clamps to mount car to jig table
2. Get material together to start testing
A. Bearing for the rear monocoque
B. Alternate CF instead of G10
C. Aluminum tube for front roll hoop
3. READ THE RULES. There will be questions raised at the meeting to see if they have been read or not.
4. Need to have reports from last weeks Goals
B. Need to get ahold of aluminum other material possiblities to bend them this week.
C. Pros and Cons of each design.
D. Start preparing for PDR
A. Refine our initial designs to optimize. Do a rigidity next week to see if the 07 car lost rigidity from the time it was last tested.
B. Individual seats needs to be looked into.
C. Pros and Cons of each design.
D. Start preparing for PDR
A. Keep coming up with desings.
B. Pros and Cons of each design.
C. Start preparing for PDR
A. Research the properties of all your materials and write a brief report on each.
B. Need to know test methods to start testing ASAP.
C. Pros and Cons of each design.
D. Start preparing for PDR