Take the cigar out of its wrapper, and inspect it. If its too old, or cracked, try not to use it. The better the blunt in the begining,
the better the blunt in the end. Now hold the blunt on the tray, and carefully slice the blunt through the outside leaf, and the
inside. Dont cut too deep, because you might ut all the way through to the otherside. Cut all the way to the end. I personally
cut off the round end of the blunt and make my own mouthpiece after i finish rolling. If you want tho you dont have too. Now
open up the blunt and slide out all the tobbacco. You should be left with the empty leaves(make sure you take out the filter a.k.a
cancer paper b 4 you put in the weed). Now break up a bunch of weed and
take out all the seeds and stems. Stems ruin blunts, because they poke holes through the paper. so remove em all.
Now take the fine weed inside the blunt leaf. Fill it uniformly so the blunt is straight. Pack the weed down tight and roll it in
your fingers so the weed stays inside the blunt. Take plenty of time to make sure the blunt is straight. You want the leaves to
overlap slightly, but not too much. Once everything is tightly held in place and the leaves are lighned up nicely, lick the overlap
and roll the blunt on the tray. Hold the overlap for a few secconds, so the leaves stick. You might have to go back and lick a
little more to make sure there is a good seal. Once the seal is solid, roll it on the tray so it stays nice and tight. Take a lighter
and run the blunt through it so it dries off the extra moisture. Dont burn it, just run it through quickly. The last step is to FIRE
IT UP and enjoy. |
