 |
 |
 |
 |
| NEW FLOOR AND FRONT SHOCKER MOUNTS |
| New floor and tunnel being put in,a section from the gearbox tunnel of a ford sierra was used to match where the center consul and gearstick would fit.then with the 5 speed sierra gearbox in place the tunnel was built around it |
| looking good and strong |
| Front top shocker mount welded in, also another plate on the inner wing to make it strong |
| Stud welded to the bottom arm,this is cast steel and welded easily,it was drilled welded and then another plate was dropped in and welded again,Solid! |
 |
| Front shocker fitted in place,these are from a peugeot 205 (rear),they seem just right for the job |
 |