Untitled

M. Mahdi^a and L. Zhang^a^,^*

^a Department of Mechanical and Mechatronic Engineering, The University of Sydney, NSW 2006, Australia

Received 12 September 1997. Available online 17 June 1999.

Abstract

The present study aims to investigate the residual stresses and surface hardening in ground components caused by the coupled effect of thermo-plasticity and phase transformation. A feasible numerical method was developed to accommodate appropriately the phase transformation in a workpiece experiencing critical temperature variation during grinding. The change of material properties was modelled as a function of temperature history. It found that if material properties are temperature-independent, the residual stresses in both the grinding direction and that perpendicular to it are tensile. The maximum residual stress in this case does not vary with the further increment of grinding heat. When material properties are temperature-dependent, however, the rise of grinding temperature promotes surface hardening and increases the maximum residual stress. The study showed that the volume growth associated with phase change plays an important role in the formation and nature transition of residual stresses. Nevertheless, residual stresses in the no-martensite zone is nearly unaffected by surface hardening and volume change. This paper offers insight into the understanding of surface hardening mechanism introduced by grinding.

Author Keywords: Residual stresses; Grinding thermo-plasticity; Phase transformation; Coupling



		This Document


			Abstract
			PDF (670 K)



		Actions


			E-mail Article

Applied mechanics in grinding—VI. Residual stresses and surface hardening by coupled thermo-plasticity and phase transformation

Abstract