V8 240z

I got lucky and scored almost two full sets of JCR California Z  fiberglass fenders.  Missing one passenger side front fender.  I only had the wife's Camry so I had to pack all of them inside, the guy at the junk yard thought I was pretty funny.  These should allow me to fit 12" wide  tires in the back and 10" wide tires up front.

Finally bought the body panels I need to complete the rust repair on the car.  I bought new rocker panels, lower door skins, lower front and rear sections for the rear quarter panels.  I will be installing the California Z rear fiberglass panels over the rear quarters, but I thought this would give me an opportunity to replace some of the body and be able to hide it if the repairs don't turn out good.

Turbo 240z

Installation of the 280zxt hood vents on the turbo 240z car.  The only cardboard I had laying around had a real nice flower design.  I followed the body lines in the center of the hood, not the edges because otherwise I would have cut into the outside structure of the hood.  The vents are placed as far back as possible without cutting into the structure underneath.  The wife gives it two thumbs up, so that is all that matters.