We have moved.
Please click the link below to visit our new page.
http://www.mindsensors.com
Site Map
Products
Sensors for LEGO RCX
Welcome to mindsensors.com
Acceleration Sensor ACC1G v2
Acceleration sensor ACC2G v2
Active Sensor Multiplexer v2
Binary tilt sensor (BTILT) v2
Dual Infra Red Obstacle Detector v2
LEGO RCX compatible electric connectors with wire
Light Emitting Brick
Motor powered Sharp GP2D12 infrared distance sensor interface
Motor powered Sharp GP2D120 infrared distance sensor interface
Passive Sensor Multiplexer v2
Pneumatic Pressure Sensor PPS35 v2
RCX to I2C interface module
Remote servo controller
Sensor Protoype Board
Serial(RS232,IIC,SPI) LCD Module
Sharp GP2D12 infrared distance sensor interface v2
Shipping Information
UltraSonic Proximity Detector v2
Wink Kit
Handyboard and accessories
Other robotics accessories
FAQ
Can I use rechargeable batteries in my RCX with mindsensors' sensors?
Will the multiplexers, dual infra red obstacle detector, or ultrasonic proximity detector work on RIS 1.0?
My DIST01 (GP2D12 interface) does not work properly. It always returns reading around 600, no matter how far it is from object. What is wrong with it?
Do LedBricks light up both LED’s at once or one at a time? How do you control which light comes on?
Can the Motor powered Sharp GP2D12 infrared distance sensor interface be used without being in raw mode?
Pressure sensor - which sensor type it should be set to on the rcx?
I am writing to you regarding the specs for a Lego Technic motor 43362. I would like to know the moment of inertia and the dimensions & mass of the rotor. I would be grateful if you could send me a data sheet.
I am interested in buying some of the sensors you have here. My question is are these sensors encased in lego bricks or do they come as they appear in the pictures (with no bricks encasing them)? Thanks
There are 4 holes on the Right (to match your picture) two on the left. How do I know how the sensor is connected to the brick?
How do I set up my USPD24 with RCX?
We try switching channels, but instead of switching to the sensor on channel two, we just get a flicker on channel 1. What is wrong?
I am interested in the 'Remote servo controller' that you have. Can you please suggest exactly which servos you tested so that I can buy the servos ? Do you also sell the servos ? Thanks
Is it possible to use sensors other than touch sensors on the passive multiplexer?
Can I run ultrasonic proximity detector on passive sensor multiplexer?
Does anyone have a sample lejos code to read the values of the Ultrasonic Sensor?
Forums
I2C and the RCX
Dead Reckoning
Operation of GD2d12 Distance Sensor
Sonar Range Finder
Dual infrared obstacle detector?
Lejos and GP2D12 Distance Sensor
Lego light sensors and the active sensor multiplexer
