____________________________________________________________________________________________
Step 1: Start out by making a piece of 6in1 with a straight edge
____________________________________________________________________________________________
Step 2: Then make anothe piece of 6in1 in the shape of a triangle. Make sure you make the tip flat.
____________________________________________________________________________________________
Step 3: Open the middle ring on the rectangle piece, and connect it to the flat tip of the triange piece.
____________________________________________________________________________________________
Step 4: Flip over the piece, open the other middle ring and put attach it to 2 rings opposite to it.
____________________________________________________________________________________________
Step 5: Flip the weave over, open 1 ring on each side of the rectangle portion and instead of passing it through 1 of the rings in front of it, pass it through the TWO in front of it.
____________________________________________________________________________________________
Step 6: Flip the weave over and repeat step #5
____________________________________________________________________________________________
Step7: Flip the weave over 1 last time, and then repeat step 5
____________________________________________________________________________________________
Thats it. That is the basic procedure for making a 45 degree 6in1 seam.
An example of a completed sleeve using the 45 degree weave is on the main page.