Biting power cords is something all house bunnies (of the western world) will do ONCE!

In Australia (240Volts) through bunny�s teeth will stop them growing, and stop him growing too.

I live in a lowly rental property and cannot preform major renovations, like installing a safety-switch, moving power points or running conduct around the skirting boards to keep cords out of bunny�s way.

I have produced a cheap alternative to moving... it should work in most parts of the world, have a look below.

N.B Excuse the 70S� looking �digs�..

It is a piece of PVC pipe cut in half length ways, to form 2 covers. Once cut is half,

(By the man at hardware store) use snips to �check-out� an area for the skirting boards, if you have them.

When the piece fits nicely to the wall, use a 20 mm or 8� nail to pin it in place.

There are probably much better ways to attach it, but this way you are only left with a very small hole when you move..�

Also I am too tight to buy paint to match the walls, but that would camouflage the covers well and add aesthetics�.

Total cost Bugger-All,

�������������������������������� I hope this page is of some use to you. If you have any ideas you would like to share with

���������� ����������������������me please send them to my email address

Below are a couple of before and afters pictures, just to drive home the point.