rear views  4 jaw I think is a d type or short taper originally, large hole in center is slightly tapered no pins though was going to make a threaded back plate for it
no noticeable wear on either chuck, 4 jaw has a lot of dings looks like it's from sitting in a tool box..

  I'd like to get $80 each for the chucks
 
also have 2 6" 3jaws, never used either, they are not new.
8.5 in chucks, 3 jaw and 4 jaw, both in great shape have back for 3jaw specs later though. 12" speedsquare in pic
collets, drawtube, and collet holder for an mt5 spindle

to the side, is a taper attachment for a 12x6 hendy conehead have complete unit, lathe is still in the garage.
   dark red is old lube, not rust.
another view of taper
rear cover
also have a 4spd gearbox drive
toolholders,
7/8x3/8 shanks on left right and center
cutoff 3/4
knurling tool is 1/2x1/2
boring bar is 3/4x3/4, with a 1/2 shaft
these are unused, india
main  page 2
Hosted by www.Geocities.ws

1