|
| Side Skirts |
|
|
| Viewer # |
| first, i started by taking a normal vertical blind and cutting it to the length I wanted. |
| Then i cut it in half so that the pieces were just the right width, to cover the tubes, yet not block any of the glow. |
| Next, I painted them black. I was going to paint them the color of my car, but I figured black would draw less attention. |
| Using a good waterproof 2 sided tape and some zipties at each end, I hooked them to part of the body that stuck down about and inch under the car and back about 3 inches (just in front of where I installed the tubes). |
| Making The Skirts |
| Installing The Skirts |
| First, I put the 2 sided tape on the body where it skirts would be attached. |
| Then I secured the skirts in place where I wanted them on the tape. |
| Lastly, I drilled a hole at each end of each skirt and put a zip tie through and secured it to insure that if the tape failed, the ties would prevent the skirts from falling off. |
 |
| Now with the skirts, the tubes aren't visable from the side anymore. |
 |
 |
| Before |
| After |
| With Skirts |
| Without Skirts |
| After installing the underbody kit, I was unhappy with the way it looked. I didn't like it because from a distance, the side tubes were visable. To stop this, I decided to make some custom side skirts. To do so, here is what I did: |
| Before |
| After |
| With Skirts |
| Without Skirts |
 |
|
|
 |
 |
 |
 |
|
 |
 |
 |
 |