|
| Headers were leaking so I had to pull it apart again. In order to change header gaskets I had to lift the motor out half way. There is about 1/8 inch of clearance on each side of this thing, what a pain! |
| Bought a new intake while it was apart again, might as well do it now and not tear it down again. Installed the fan and radiator too. |
|
| New Edelbrock StreetMaster intake...all ready to bolt on. |
| Manifold bolted on...that took off more than 50 Ibs off the front wheels going to an aluminum unit. |
|
| All back together again...now that looks a lot better. Also had the alternator converted to a single wire internal regulated unit to tidy up the compartment. |