INFO PAGE
Only 'POST-TOP' full open details and 'Bell-Saucer' Overhead general outside shapes
and component parts details are available for moment !
"Luminaires Components" menu (exposed below "info") - contains the following :
- All "Standard Post-top Luminaires" component parts, of all types, exposed in full-detail mechanical drawings.
- Bell-Saucer Overhead Luminaires - large-size component parts details.
"Luminaires Examples" - contains a menu with links to :
- example of an assembled post-top luminaire with pieces exposed in "Luminaire Components" menu -
( Lateral view; Vertical section; Cutt-off classification and suitable lamps ).
- examples of BellSaucer overhead luminaires - types, outside shapes and dimensions.
- examples of Low-voltage fixtures - types, outside shapes and dimensions.
Drawings which show both dimensions' values in millimeters and inches, usually, values in millimeters are written on the left or upside, and those in inches are mentioned on right or down one.
TERMS OF DESIGNS USAGE
The main term of mechanical drawings usage, which represents luminaries component parts, for manufacturing, is to be used as they are designed.
If our design is not suitable for your way of manufacturing, or concept, you may modify in your way - as you consider more suitable for you - only the interior (inside) part(s) (components) of the luminaries ; preserving the outside shapes and dimensions.
Any kind of changes are allowed to all components or solutions, which are hidden in the assembled luminaire.
More exactly, you have to keep the outside of luminaries untouched.
Any kind of hacking, or combinations of your own solutions, which change the outside shape and dimensions of the assembly of the luminaire, are forbidden.
Only in case of joining solution between the luminaire with the pole's top end, are changes allowed - related to the outside shape and dimensions..
All changes related to luminaries and pole top ends dimensions ; are allowed only from smaller dimensions to larger ones, but not more than 13mm or 1/2inch.
For example : It is allowed to redesign a base suitable for 60mm (2-3/8") to be(come) suitable for 73mm (2-7/8") pole top end pipe (tenon).
The below part of 'Bell-(Cup)-Saucer' Luminaires (as body of fixture or as lampshade), may be considered as "inside", too. Therefore, any changes are allowed on all below parts, which are above the horizontal lowest plane, of the saucer-shaped-shield, or on those of lampshield (inside of lampshade).
Notice !
Anytime, if there are more suggested values for the same dimension, the manufacturer may chose those, which he considers more suitable.
SITE MAP
home page