The dual chamber bong is much the same as the classic single chamber bong. It simply has an extra chamber. The purpose for this extra chamber is to cool the smoke down enough so that pussy inexperienced stoners can take a full cone in one hit. To make yourself a lovely dual chamber bong you'll need - two coke bottles (I like 600mL)
                - tubing
                - a lighter
                - a conepiece aka bowl
                - duct tape
1. This is gonna be hard to explain cos I suck, so refer (reefer) to the pic if you don't get it. Ok, take the first bottle and use the lighter to melt a hole (large enough for the plastic tubing) 2/3 the way up the side. Jam the tubing in before it sets. Be sure that the tubing if roughly 1cm from the base of the bottle. Cut the other end of the tubing so that about 8cm is still protruding from the side of the bottle.
2. Use duct tape to seal around the hole to make it air-tight.
3. Get the second bottle and melt a hole in it's side at the same level as the hole in the first bottle. Take the tubing thats sticking out of the first bottle and stick it into the newly melted hole in the second bottle.
4. Seal around the tubing to make it air-tight.
5. Get a lid from one of the bottles and melt a hole in the top large enough for some tubing. Make sure that the tubing can reach from the top of the bottle to the bottom then stick it into the hole and use duct tape to seal. Place cone piece into the slightly protruding tube at the top of the lid.
6. Fill both bottles with water so that the bottom of the tubing is fully submerged and screw the lid with the cone piece onto the second bottle.
7. It is complete. Pack it, light it as you suck through the opening in the open bottle. Amazing, cool, smooth smoke.
Click on this link to go back to the WEED page.
Hosted by www.Geocities.ws

1