- about 10 cm of tubing large enough for your cone piece to sit in.
- a cone piece or bowl
- a lighter
- some duct tape.
1. Take the lid off you coke bottle and drink all the coke. Use your lighter to melt a hole in the side about 5cm from the bottom. Before the plastic sets jam the tubing into the hole so that it touches the bottom on the inside.
2. Put tape around the hole to make it air-tight. Fit your bowl into the protruding end of the tubing.
3. Now on the opposite side of the bottle in relation to the tubing entry point, melt a second hole about 15cm from the base of the bottle. This is the shotty hole or carb hole (depending on your nationality). You should be able to cover the hole with your thumb.
4. Now fill the bong with water so that the end of the tubing inside the bottle is totally submerged. To smoke simply put your weed into the bowl and light it as you suck through the mouth of the bottle. The water should bubble, make sure your thumb is on the shotty. When the bowl is cashed / ashed remove your thumb from the shotty allowing the remaining chamber smoke to rush into your lungs.
This is a picture of the finished product.
Click on this link right here to return to WEED.