                              October 30, 2003
BNSF Railway Co.
TEXAS DIVISION

                            GENERAL ORDER NO. 92

TO ALL CONCERNED,

SUBJECT: Ft Worth Subdivision Amendments

Texas Division General Order No. 89 is cancelled.

***********************************************************************
* Division General Order No. 89 is cancelled and reissued with        *
* the addition of Hy Rail Limits Compliance System in effect          *
***********************************************************************

Texas Division Timetable No. 5, in effect January 20, 2002 is
amended as follows:

Effective 0900 hours, October 30, 2003 Hy Rail Limits Compliance
System (HLCS) is in effect.


Effective 1201 hours, October 24, 2003 a G sign will be installed
on the WB signal 2831.    Condition Permanent


Page 13  Radio Communication

Delete:                    CH   DS   MC    FS    EMER
Gainesville to Crowley     36    1    4    5&6    9
Crowley to Belco           30    1    4    5&6    9

Add:                       CH   DS   MC    FS    EMER
Gainesville to E. Blum     36    1    4    5&6    9
E. Blum to Belco           30    1    4    5&6    9


Page 14, Item 1(D) Speed - Other

Delete:
All trains are restricted to 20 MPH on the main track between
MP 351.4 and MP 353.2, unless it is determined from the Yardmaster
at Saginaw that no crews are making air brake inspections on adjacent
tracks. Ring bell continuously while passing through these limits.


Page 13, Train Dispatcher Telephone Numbers

Delete:
DS 22 - (817) 234-2322, Fax (817) 234-2422
DS 24 - (817) 234-2324, Fax (817) 234-2424

Add:

Red Rock Split Dispatcher(DS114) Monday through Friday 0900 - 1700
will control Gainesville to Justin. (817) 234-2114  Fax (817) 234-2421

Ft Worth Dispatcher(DS22):
Monday through Friday 0900 - 1700 will control Justin to Rio Vista.
Monday through Friday 1700 - 2300 will control Gainesville to Rio Vista.
Monday through Friday 2300 - 0900 and on weekends will control
Gainesville to Pendleton.
Will control the Saginaw Interlocking at all times.
(817) 234-2322  Fax (817) 234-2422

Lampasas Dispatcher(DS24):
Monday through Friday 0900 - 2300 will control Rio Vista to Temple
(817) 234-2324  Fax (817) 234-2424


Page 14,  Item 7. Special Conditions.

Delete the entire section concerning REMOTE CONTROL OPERATIONS
(previously added to Time Table by General Order)
ADD:

Alliance Yard -

REMOTE CONTROL OPERATIONS

Signs located at MP 368.5 (Lambert) and MP 360.9 (West Haslet)
designate the Remote Control Area at Alliance Yard.

REMOTE CONTROL ZONE

On the west end of Alliance Yard, two Remote Control Zones (RCZ) are
established on the 7130 and 7133 leads.  Remote Control Zone signs will
be placed at the outside limits of each zone to designate the limits.

Remote Control Zone 1 is established on the 7130 switch lead.
The east limit is the west 7132 switch. The west limit is the
clearance point on the 7130 lead 100 feet east of the 7133 lead switch.

Remote Control Zone 2 is established on the 7133 switch lead.
The east limit is the 7162 crossover switch. The west limit is the
clearance point on the 7133 switch lead 100 feet east of the
Roundhouse switch.

Remote Control Zone sign on the 7130 lead is placed on the left-hand
side.

Remote Control Zone sign on the 7133 lead is placed adjacent to
Roundhouse lead on the left-hand side.

ACTIVATION / DEACTIVATION PROCEDURE

Remote control operator will notify switch tender when Remote Control
Zone is activated or deactivated.

Movements desiring to enter Zone 1 must contact the remote control
operator on Channel 64 to deactivate the Zone prior to entering the
limits.
Movements desiring to enter Zone 2 must contact the remote control
operator on Channel 41 or 25 to deactivate the Zone prior to entering
the limits.

If unable to contact the remote control operator, contact the switch
tender to determine if either Remote Control Zone is activated.

Temple Yard -

REMOTE CONTROL OPERATIONS

Signs located at MP 221.3 (Fort Worth Subdivision), MP 217.5 (Galveston
Subdivision) and MP 219.9 (Lampasas Subdivision), designate the Remote
Control Area at Temple Yard.

Page 15,  Item 7. Special Conditions

Add:
On the Texas Division in block signal territory, when a train is
passing the approach signal (displaying other than clear) to a
control point, a crew member must trasmit the following by radio:

Train Identification - Initials engine number and direction
Signal Name -
Control Point Location -
Track - (on single track main track designation is not necessary)
Speed -

EXAMPLE OF TRANSMISSION:
"BNSF 6301 EAST APPROACH SIGNAL WEST MORGAN AT 30 MPH"

Delete:

Unit Trains -- Loaded unit trains of grain, rock, coal, taconite,
potash, coil steel and other such type bulk trains, when practicable,
must not take siding. If necessary for these trains to take siding,
speed entering siding and exiting from the siding is restricted to
10 MPH through turnout only.


APPROVED:
M D DEALY
V.P. OPERATIONS

GENERAL ORDER(S) FOR THE TEXAS DIVISION IN EFFECT
=========================================================================
| 1,10,29,58,61,65,69,81-82,86-88,90-92                                 |
=========================================================================
.

