| Supplies DUNCAN BEARING BUTTERFLY Duncan Butterfly Team Losi Bearings Yomega Spacers Bee size Nut and Bolt Tools Clear Nail polish. Krazy glue Drill 3/8 spade bit Dremel Dremel cutting bit ( or anyhting to cut the bee size bolt) Knife 2 pair of Pliers Instructions Take your butterfly apart and lay all of the pieces nearby. Put clear nail polish or krazy glue on your starbursts. With your drill (or drill press) drill a hole deep enough for the spacers to lie flush with the yo. Assemble the yo-yo bolt, half,spacer,bearing,spacer,half,nut. Thighten the yo up with the pliers. Make the gap how big you want it. Make a mark on the bolt where the excess bolt comes through the nut. Cut to the mark so the bolt goes just to the end of the nut.Glue the nut and bolt in place. Put the pogs on.If you want you can make some weight rings out of solder, or just use team losi rings. By Me (XMOCHA) |