Main Fuel Relay Kill Switch
To help deter car thieves this is your basic fuel pump kill switch. DO NOT use a lighted switch with this mod because it will give the location of the switch away to the thief.  Please consult your manual or favorite forum to find the right fuel pump power wire. In no way am I responsible for any damage you may do to your car. You assume full liablity for your action. If you do not agree to this condition then do not do this mod.
Items Needed:
12 volt Automotive Relay

Plain SPST switch

Spool of 16 gauge wire

Female disconnect connectors

Ring connector

Butt connectors
DIRECTIONS:
Step 1: Before you start cutting, crimping and connecting first decide where you are going to put the switch. Places where you DO NOT want to put the switch are: Under the dash. In the glove box. Under the drivers or passanger seat. Or in plain site. Keep the switch and it's wires out of sight.

Step 2: Locate a place near the fuel pump for the relay.

Step 3: Locate a power source for the relay. Most cars have spare connector in the fuse box. Locate one of the connection that is only on when the ignition is on.

Step  4: Remove the negative cable from your battery.

Step 5: Run your wire from the fuse box to the switch. Remember to keep the wire out of sight.

Step 6: Run your wire from the switch to connector 85 on the relay

Step 7: Run a wire from 86 to the chassis ground. And keep this wire out of sight

Step 8: Locate fuel pump power source line. Cut the power source wire

Step 9: Attach butt connectors to the ends of the power source wires.

Step 10: Connect the wire coming from the dash to connector 87 on the relay

Step 11: Connect the wire from the pump to connector 30 on the relay

Step 12: Reconnect the negative cable to the battery.

Step 13: Make sure the switch is on. Turn the key to the "On" position and wait a second for the relay to power up and then start your car.
Back to MOD Page
Hosted by www.Geocities.ws

1