Body work on my challenger

The trunk floor will need to be replaced.

____________________________________________________________

I scraped the undercoating off the entire car using a putty knife and a propane torch. (make sure you wear gloves, hot undercoating doesn't feel good on your hands.

____________________________________________________________

After the undercoating was done i sand blasted the entire underside, inside and engine compartment.

____________________________________________________________

Both floors need repairing. The car was hung on scaffolding to make it easier to work on.

____________________________________________________________

New Floors are from Year One. they didn't fit perfect but it was better than the sheetmetal and fiberglass that was in there.

____________________________________________________________

A chain hoist with trolley was used to suspend the rear of the car. This makes it easier to work on the rear of the car. The quarters were both cut off

____________________________________________________________

Next Stage: More Body Work

Back to Main Page

Previous: Begining and dissassembly

This page hosted by Get your own Free Home Page