Solidworks Flashlight

For my GC120 class we were required to do a project. Part of that project required that we find an object made of several parts and model it in Solidworks. I choose a small flashlight to model. I had to measued all of the parts in order to model them. I have taken pictues of the rendered version and put them up on this page. I modeled each part seperatly so I was a little worried that it may not assemble correctly, but (after a little work) it looked better than I thought. At some point I will try to get some pictures of the actual flashlight for comparison.


This is looking through the transparent lens of the flashlight.


This is picture of the flashlight fully assembled.


This is the fully exploded flashlight.


This is a close up of the top of the flashlight.
(These pieces don't actually come apart.)


These are the batteries I textured and the bar with a spring on it.


This is the main body of the flashlight.


This is the light bulb and the two pieces that hold it in place.


This is the last 3 pieces assembled.

1
Hosted by www.Geocities.ws