KENAIR18  BIG BIRDS   

Home
Up

Other Kenair Webs

MB Electrics

Manitoba R/C Report

R/C Newbie

MB Zone

 

backup email

 

My IMAC planes (click on pics to enlarge)

This Sukhoi is built from the Goldberg kit with some mod's. I used plug in wings to increase the span to 78", a removeable top hatch, and put the landing gear on the fuselage. The plane flies very well with an US 41 on CH ignition.

kk su26 tip port.JPG (24879 bytes) kk su26 front.JPG (28184 bytes) su 26 rear a.JPG (162386 bytes) su 26 side.JPG (160829 bytes)

 

I built this "Edge 200" from a set of Laser 200 plans by Wayne Ulery in MAN. I used a Q52 engine, plug in wings for a span of 87". A nice honest flying plane.

 edge 200 top.JPG (177480 bytes) edge 200 top2.front.jPG (134294 bytes) edge 200 left low side.JPG (91900 bytes) edge 200 left top3.JPG (170242 bytes)

 

Laser 200 and Cap 232, both Lanier kits, each powered by Zenoah G62's and both are excellent flyers.

big red low aa.JPG (14989 bytes) bigred1.JPG (53922 bytes) laser 200 l rearatest.JPG (54580 bytes) laser g62a.JPG (202797 bytes) laser 200 rear.JPG (38976 bytes) kk laser 200.jpg (21956 bytes) 

kk cap tip.JPG (20287 bytes) cap232lrlJPG.JPG (19354 bytes) cap side.JPG (163485 bytes) cap g62.JPG (179987 bytes) kenandcapJPG.JPG (42830 bytes) cap232leftfront.JPG (21129 bytes) cap232reara.JPG (31338 bytes) cap at assessippi.jpg (46843 bytes) cap232.JPG (35182 bytes) 

I got this 300s from Siggi, it was built from the Ohio kit. G62 powered. I scratched the red one from the Ohio plans and powered it with a Q52. They were nice flying planes, both later sold.

Hosted by www.Geocities.ws

1