| "LOCKER" This tool is machined out of solid aluminum and is unique. As you can see, the upright hole is offset and also the boom clamp can be put in from either side to keep from interfering with your tail rotor pushrod. If you are using a short flybar, position the upright with the hole closest to the main shaft, then turn nesting V block towards main shaft also. This gives you clearance from the flybar paddles. Lay flybar in the V and secure with the Velcro strap. Now open the thumb screw and adjust the flybar level. Now you can set your main blades to your liking without disturbing the flybar. The tool breaks down to be stored in very little space. |
