 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
|
|
Below is the sub box firing into the upper deck. Notice the fan inlet in the lower right picture of the trunk.� Behind this panel is the Amplifier rack.� If you look at the picture to the left it shows the side where an Orion DEQ30 and the Alpine 6 disc changer is mounted. |
|
|
|
 |
|
|
|
 |
|
|
|
|
 |
|
|
|
|
Picture of the inside of the sub box trim panel. |
|
|
|
|
|
 |
|
|
|
|
|
|
Sub box with and without trim panel prior with an old version of amp rack mounted underneath.peting. |
|
|
|
|
|
 |
|
|
|
|
This is a pic of the 27Vs looking through the rear deck. |
|
|
|
|
|
|
 |
|
|
|
 |
|
|
|
|
|
This is the rear shelf, notice the sub grill I plan on redoing this when time permits to make it look completely flat and original this was quick and dirty. But almost unnoticable with the head rests down. The sides are contoured to fit the "dip" in the rear shelf. |
|
|
|
Picture of the left sdie trim panel (factory recarpeted) where the factory non/DSP amplifier was. I replaced the amp with a DEQ30 from orion, Theata TLC, and added the aftermarket Alpine 6 disc changer in its location. |
|
|
|