Infinity Wrapped in Limits

 

Re-viewing Force

Finding the Limits of Action - Maximum and Minimum

 

 

Home Page --- Secret of Nature

 

 

Abstract: Science depicts force by a straight-line arrow. This representation has limits. These limit are explained and a new view is put-forth that can account for all the development [Relativity and Quantum Phenomenon] in science at the same time go one step towards explaining the oneness and unearthing the Unification Theory

 
Science represents force by means of a straight-line arrow. The head of the arrow represents the direction of the resultant force. See Fig.-9 {if the figure is not open click  sfig-9 ]

            

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


Fig.-9 represents the force and direction in a simple manner. A closer look says that the force has to be applied over an area to obtain the desired result on a chosen particle. The area has a minimum, optimum and maximum that is related to the particle or the system chosen. Beyond the minimum and the maximum it cannot produce, the desired result that is the mechanical displacement of the body. In other words, force is most effective when it is applied over an optimum area and its efficiency decreases as we go to the limits. [A little confusion might occur here because we do see in nature object responding to force below the described limit. This would disappear if we assume that our system in reality has a series of layers. A clear picture could be visualized if we extend our picture to a minimum point. We will come to this aspect later]. This vision invariably means that four points covering a circular area should represent force. See Fig.-10 [If the fig is not open click sfig-10 ]

The fact that the force has minimum, optimum and maximum value invariably means that the four points of the force is flexible between two limits; one to the outside the other to the inside See Fig.-10. This means the ring of force has an outer radial limit and an inner radial limit; If it goes beyond minimum it falls to ‘zero’ and if goes beyond maximum it falls to ‘one’. In other words beyond and at the limit, the force breaks down. [We will understand the statement as we go on]

 

 

 

 

 

 

 


                                           

 

 

 

 

 

 

 

 

 

 

 

 

 

The Fig.- 11 [ if the figure is not open click – sfig-11 ]brings out how I imagine these four forces. ‘A’ and ‘B’ are one pair and ‘C’ and ‘D’ are a second pair. When ‘A’ and ‘C’ on the vertical plane tends to the maximum simultaneously ‘B’ and ‘D’ on the horizontal plane tends to the minimum level. The possible link between the two pair is also shown in the figure.

The force we visualize is understood from the action it renders on the system. We know that our system opposes the force acting on it. The force with which the system opposes depends on the force with which the left and the right are held. Simple reasoning tells us that, one has to apply an external force, which is more than half of the force with which the system is bound.

Classical Science has its beginning in the above base.  It assumes that there is a minimum

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 


force required for moving an object. The displacement it causes on the system depends on the force applied beyond this minimum.  It deals only with the optimum situation described. The optimum here means a situation where the vertical and horizontal components are equal and force takes perfect cyclic form on perfect cyclic surface. The force according to science acts through the center point “O” and passes through O1 [See Fig.-3 — click -- Secret of the Fundamental Particle] This is a non-existent case because non-equilibrium is a basic requirement.

Force as visualized by science is inadequate to answer our day today experiences. We know that all force exerted on a system does cause some type of stress on the system. Little force produces little actions. These little actions add up before a visible action and reaction takes place [Nonlinear Physics]. Science has quantified force and has developed methods to predict the external action and reaction [Motion of the system]. However, it has failed to figure out underlying process. There is a qualitative change within the system before any quantum actions are witnessed. To understand the basic process of action and reaction we must develop a new vision of force.

 

Click here to go to next page --- New Vision of Force

 

Click to go to Home page – Secret of Nature

Hosted by www.Geocities.ws

1