Drill a 1" hole into each section right through the middle. Make sure they match up!!
Begin with your floralier and the extra tray.
Push your 2 1/2' of 3/4" pvc w/the connector on it into the top tray.
Put the dreain section and other parts of the Floralier on after.
Attach your lamp housing shoulders with 2 screws. Be sure to measure exactly.
Now take your bowling pin, either the "e" or crown model, and cut it in this shape.
Drill a hole into the neck of the bowling pin, and attach the neck to it. Put your poppet onto the neck.
Take about 2 1/2' of 1/2" pvc and put this through the throat. Place a connector at the top.
Put a 1 1/4 piece of 1/2" pvc on the other side of the coupling.
Place the soapdish over this.
Attach your XL7 to the back of the bowling pin.
These are the basic steps for building Crow. For some helpful tips, click here.