I want to be an Engineer
Below you will find the steps that you must complete for this project.
Step 1 |
Get with your group members and decide how the simple machines
you researched would fit into an actual automobile. |
Step 2 |
You will continue with step 1 until the
following simple machines have been used: |
Step 3 |
Together, give your car a name: This name should reflect your groups personality. |
Step 4 |
Once you have decided on placement of the simple machines in the automobile , you will begin the final drawing. SKETCH EVERYTHING
INCLUDING EXTRAS. |
REQUIREMENTS:
· use only the paper given to you by the instructor for
your final draft of the car
· use a pencil
· a ruler must be used for all straight lines and a
compass can be used for circles
· the drawing must be CLEAN and NEAT. Sloppiness will
result in a loss of points for you and ONLY you
Engineer Evaluation
Simple Machines |
Appropriate representation Of each simple machine |
Each simple machine is used in Final product |
Are simple machines in |
Lever |
points 0 or 2 |
points 0 or 3 |
points 0 or 2 |
Screw |
points 0 or 2 |
points 0 or 3 |
points 0 or 2 |
Wedge |
points 0 or 2 |
points 0 or 3 |
points 0 or 2 |
Wheel and Axle |
points 0 or 2 |
points 0 or 3 |
points 0 or 2 |
Pulley |
points 0 or 2 |
points 0 or 3 |
points 0 or 2 |
Sketch is on correct paper -- points 0 or 10
Pencil used for sketch -- points 0 or 10
Lines are straight and circles are represented accurately -- points 0 or 10
Clean looking -- points 0 1 2 3 4 5 6 7 8 9 10
Neat in appearance -- points 0 1 2 3 4 5 6 7 8 9 10
All other structures such as trees, rivers, houses, people, etc... --points 0 1 2 3 4 5 6
7 8 9 or 10
Presentation
· Takes presentation seriously -- 5 points
· Speaks loud and clear -- 5 points
· Holds audience attention -- 5 points
· Can answer questions from instructor and
classmates -- 10 points
TOTAL POINTS POSSIBLE = 120