Installation:
1. Turn off all gas appliances
in unit.
2. Close the gas vapor valve on
your L.P. gas cylinder.
3. Unthread the brass P.O.L.
fitting from the gas vapor valve (This is a left hand thread
so turn the brass nut with the notices on ^clockwise to
loosen.).
4. It will be necessary to move
the P.O.L. fitting with the attached regulator and hose back
away from the gas vapor valve far enough to place the
Extend-A-Stay tee fitting between them. This usually
requires moving the regulator cover too. See Picture #4.
5. Thread the male P.O.L. end of
the Extend-A-Stay tee into the cylinder valve -again, a left
hand fitting (turn counter clockwise to tighten.). See
Picture #1.
6. Thread the original P.O.L.
fitting in the female P.O.L. end of the Extend-A-Stay tee.
This is also a left hand thread (turn counter clockwise to
tighten.). See Picture #2.
7. Securely fasten regulator and
hose assembly to vehicle to avoid possible damage due to
"over-the-road" vibration.
8. Tighten all connections, turn
gas on at cylinder valve and check for leaks with an
ammonia-free soap solution. If bubbles appear, tighten
connections until bubbles stop.
9. Re-light appliance pilots.
