Modifications
Be sure to visit my AMMO MODIFICATIONS
The wonderful world of modifications... this is how to make a good weapon a great weapon.
Basic Modifications:
Rubberband: This is when you loop rubberbands around the cocker, to increase discharge force. A very useful mod.
Spring Stretch: This is when you strecth the main spring, in cocking guns, there is no vast improvement with this mod, it only adds a couple of feet
Specific Gun Modifications
The Big Bad Bow, Defender T-3, and Triple Strike
Simple. Just remove the plug from inside the barrel. I had my dad do it with two awls. If you cannot do this just sand off some of the barrel. Now it will shoot micro darts and in the "Triple B's" case it will shoot them 70 feet! It also makes the triple strike better, but the darts will fall out.
Supermaxx 5000
I can't tell you what this does to the gun. I did a full overhaul on mine and it is unbelievable. First, on the arrowshooter I poked out the air restrictor. This makes it shoot micro darts. Then, you punch out the mesh air restrictor where you screw on the barrel, it is orange. Then you drill a hole through the place the barrels go, as a scope. Then, you throw out the ball shooter, because it sucks. Now you should be done. Simple as that, a crappy gun into the ultmimate gun. ENJOY!!!! Oh yeah do not shoot at peoples faces, it will blind them. I got shot in the eye and let me tell you it was not fun.
Wildfire
Wildfire not good enough for you? You can open it up and remove the sticks in the barrels, this will give it the ability to shoot micro-Stefans and regular micro darts a little farther.
*Note: I have seen many Wildfire break this way, so use your own judgement*
Chainblazer
I have seen so many people complain about a lost orange piece for a Chainblazer (Sal) Well, I have a way to solve your problem. If you have four links from a chain you can do this. Cut each link apart. Put the licks in the holes in the place where the chain was held. Now wrap duct tape around. Now you have a four shot, never jam, Chainblazer.
Hidden Shot
Cut 1 and a half inches of 1/2 inch PVC, slide it over the old Hidden Shot Barrel, so about 1 inch of PVC is hanging off, duct tape it on. Use Kobra modified Supermaxxs and you should get very good ranges.
Mod By Kobra406
Lock n' Load
Take off that big green cocking thing, put a keyring at the end of the cocker, open her up, stretch the spring (Could replace with a Blazer spring), Yank out the pole in the barrel, use some Artificial Black Laramis. You can PVC the Lock n' Load so it looks like a silencer, as soon as the barrel tapers, cut it and replace with PVC. Note: Does not actually "Silence" the LNL.
Supermaxx 1500
Open it up, plug the air release valve. Replace all of the barrels with PVC, which is quite simple, or you can make one PVC barrel, which you would put PVC instead of the 4 barrel rotater.
Crossbow
I love this mod. First off, use PDDs, they kick arse. Tape up the holes in the barrel, open her up, stretch the spring, rubber banding isn't neccesary I feel it puts too, much stress on the plunger. Put the barrel in the front, this is done by cutting the air hose to about an inch, and the barrel will come straight out of where the power is generated, hot glue the barrel in place.
Arrowstorm
Sand out the lines in each barrel with a Rotary Tool, or Cylindrical hand file. Use micros, they go about 85 feet angled, and Artificial Black Laramis go about 75 feet angled.
BACK to my main page