Homemade Bongs
Gravity Bong
All You Need:
1 litre pop bottle and cap
Scissors or a knife
2 litre pop bottle(no cap) or a bucket
Tin Foil or screens
A bowl peice
Lighter
Tape or chewing gun
And some fucking weed
Take 1 litre pop bottle cut it at the bottom before it curves. Then take the 2 litre and cut it off at the neck before it curves. A bucket can also be used instead of a pop bottle. Fill the 2 litre with water and then put it aside. Take the 1 litre's cap and stab/cut or dill a hole in the top of the cap.However you make bowls for pipes and bongs is up to you but make something the shapes like a bowl and put tin foil or screens as a filter. Connect the bowl to the top of the cap. Screw the cap back on to the 1litre. Some people don't go to class so they might not know how is works so load the bowl and put the one litre in to the two litre full of water but not to the top about 3/4. Light the cronic and pull up very slowly to the suction pulls all of the smoke in. Do not let the pop bottle come out of the water or you will waste the weed.. Un screw where the bowl is and take the biggest fucking toke ever. As you suck smoke in the bottle is will cause it to sink and go deeper into the bottle, this acts as basically a huge rush hitting your lungs. Good Luck
Simple Quick Pipe
All You Need:
Pop can
Pin/Pen/Knife anything with a sharp tip
Lighter
Cronic
This is a simple easy to make last minute pipe. Take the pop can and make an upside down triangle from the place where you normally drink from. After that shape it like a bowl and so no weed falls off. Poke holes in one area so it makes like a screen. Load the weed by the holes Light it and Get high.
Hosted by www.Geocities.ws

1