|
 Steel
Construction Eccentric Press
The body
of our 30-40-60-80-130-200 tons presses are manufactured as steel
construction and supported with necesary resistance as per its
pressing power.
Quality material - Qualitied
workmanship
Our presses are combined with the top
quality material, qualitied workmanship and
esthetics.
Parallelism and set square
Head rear slide
can also be adjustable like front slides.Thanks to this,
nonregulation, which may occur between the head and table as
time passes, is casily cradicated.
Lubrication System
In order to provide a
practical and easy-lubrication, a manual double-hand
controlled electro-pneumatic system is installed.
Revolving
Bearings
Made of special alloyed bronze material
resistant to high cycles and stroke.
Cotter
System
Clutch cotter is made in two pieces to provide a
convenience in changing.
Crankshaft System
In
order to provide an endurance against the over-stokes
exceeding the press power and material weariness, the
crankshaft eccentric is made filled. Thus, the critical
cross-section diameter is provided to be maximum and the
critical cross-section number to be minimum.
Single-stroke System
In
order to prevent the hazards which may occur in case of
leaving the clutch system continually open, the single-stroke
safety system in fixed.
Fuse
A
fuse system is installed for the purpose of decreasing the
possible damages to minimum when exceeding over the press
capacity.
Guaranty
Guaranteed one year against the
material and workmanship defects.Use faults are
exempted from the guaranty.
Technical
Service
The malfunctions which may occur within the
guarantee period and in the following years are solved by
our service specialists as soon as
possible.
| 
