 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
'68 Hemi Restoration page 4 |
|
|
|
Rear quarter area and rear valance and caps |
|
|
|
 |
|
|
|
To the left is the new rear valance and end caps welded into place... The valance has an adjustment to be made, but it isn't anything bad at all. Over all, the jpb came out very nice... Smitty will finish up with the body filler, but only on the quarter side of the cap. I'm not going to fill in the gap between the valance and caps, as per the factory.... The sheetmetal will get corrosion protection, so all will be well in the future..... The lower rear quarter section is waiting to be installed while detail work in the trunk is finished... |
|
|
|
|
|
 |
|
|
This is the extent of the work that is needed on the rear driver's quarter... Not too bad at all.... It's lookin' pretty darn good... |
|
|
|
|
|
|
'68 Hemi Restoration next |
|
|
|
'68 Hemi Restoration previous |
|
|
|
Home page |
|