In the picture at the right, you can see a fuel tube coming out of the EZ-Start system. This fuel tube is placed over an aluminum "elbow" tube (or a pressure fitting, from you LHS) that is placed in a hole drilled in the EZ-Start case. The hole needs to be drilled in the center of the EZ-Start final drive gear. Zip tie everything into place, so that the end of the fuel tubing is easy to reach, and find something to cap the fuel tube with (a screw works well). Then all you do is uncap the line, and squirt electric contact cleaner into the fuel tube to free the bearing.
If you are not sure what size pressure fitting to use, take the EZ-Start system off the engine, and measure the inner diameter of the final dive gear. The pressure fitting should be no larger than that (to avoid damaging the EZ-Start System)
Thanks to Dudnone for this mod...
