1992 SSEi 3800 s/c to Fiero Swap


IMPORTANT NOTES


Although all info here is believed correct for this application. However if you do use this
you do so at your own risk. The author is NOT responsible for any problems from the use of this material.
While every attempt has been made to be as simple as possible, all work should be done after any effects
of changes are understood and found to be the result desired.

92 SSEi PCM Connector 3 (GREEN)
PIN # USE Wire Colour Connection Within Harness How to Modify
c1
Service Engine Soon
BRN-WHT
SES ind Instr Panel
c2
A/C Comp Ctrl
LT GRN-BLK
A/C Relay
Not Used
c3
Coolant Fan Hi spd Ctrl
DK GRN-WHT
Coolant Fan Relays
c4
Coolant Fan Low spd Ctrl
GRY-BLK
Coolant Fan Relays
c5
Vapour Cannister Purge
DK GRN-YEL
Cannister sensor
Use 99 GA cannister
c6
TCC Ctrl
TAN-BLK
Tranny in harness
Not Used
c7
Coolant Temp Ind Ctrl
PNK-BLK
Instr Cluster
Splice to Fiero Harness
c8
EGR Ctrl
RED
EGR Valve
c9
Boost Ctrl
GRY
Boost Solenoid
c10
EGR Ctrl
BRN
EGR Valve
c11
Idle Air Mtr Coil A Hi
LT BLU-WHT
Idle Air Crtl Valve
c12
Idle Air Mtr Coil A Lo
LT BLU-BLK
Idle Air Ctrl Valve
c13
Idle Air Mtr Coil B Lo
LT GRN-BLK
Idle Air Ctrl Valve
c14
Idle Air Mtr Coil B Hi
LT GRN-WHT
Idle Air Ctrl Valve
c15
DK BLU
c16
TAN
D1
none
D2
Cruise on/off input
GRY
Not Used
D3
Cruise set/coast in
DK BLU
Not Used
D4
Cruise Res/accel in
GRY-BLK
Not Used
D5
Cranking Fuel Enable
DK BLU
Passkey Module
Wire to new Passkey Location
D6
Crankshaft Ref In HI
LT BLU-BLK
Crank Sensor
D7
Vehicle Speed Output
DK GRN-WHT
HUD Ctrl Module
Optional
D8
None
D9
None
D10
Vehicle Speed Output
DK GRN
Speedo
Splice to Yellow At Speed sensor
D11
Vehicle Speed Output
RED
MFO Module
Not Used
D12
none
D13
Vehicle Speed Input LO
PPL
VSS
TO Fiero VSS
D14
Vehicle Speed Input HI
YEL
VSS
To Fiero VSS
D15
Shift Solenoid B Ctrl
YEL-BLK
Tranny
Not Used
D16
>Shift Solenoid A Ctrl
LT GRN
Tranny
Not Used

|

Hosted by www.Geocities.ws

1