| THE MS-01 |
| YOU WILL NEED: all parts are PVC 5' of 1.5" PVC pipe (barrel 3" to 1.5" reducer ( connects chamber to barrel) 1.5 feet of 3" PVC (combustion chamber) 3" threaded cleanout 3" threaded end cap 1 can of PVC glue 1 can of PVC primer CONSTRUCTION: 1.THE BARRELL- cut your 1.5" PVC pipe with a hacksaw to about 5 feet 2. prime the end of of the peice you just cut and the inside of the reducer, then slap some glue on both of the primed peices and put them together, make sure it's in there ALL of the way. 3. THE "CHAMBER" cut the 3" PVC pipe to about 14", the longer you make it the more powerful it is, improvise on this one. When that's done you can now prime the outside of the 3" PVC and the inside of the reducer, slap some more glue on the ends you have primed. Try not to inhale many of the fumes from the glue or anything. 4. Now your ready to put the cleanout on the end of the 3" combustion chamber. Prime each side like usual and put the glue on. Don't get any of the glue on the threads. Now you have succesfully completed the "body" of your gun. Pretty cool huh. 5. THE IGNITOR- Here comes the hard part. Drill a hole in the side of the body of your gun about 3 to 4 inches away from the end of the cleanout cap. Make sure that your drill hole will fit the size of the sparker nicely. When that is done all you have to do is stick your ignitor in there and tape up any gaps where any air can escape around the side. and now your done. NICELY DONE MY FRIEND! 6. FIRING- read the "Done with the gun, now your ready to fire" page on the plans page. |
 |
| (c) 2001 by Dane Love |
 |
|