 |
| Throwing Darts |
 |
| Throwing darts are easy to make. All you need is: - A long Screwdriver (-) - Duct Tape - Straw - Already cut Stefan without bb and glue 1) First off, take your long screw driver, and poke about 1/2 inch into your darts end. Spin it around to make it a bit big. 2) Now take your straw, and poke it in that same hole. Spin it around to get deep. Now take the long screw driver and poke it down the hole of the straw so that can be the navigator. Just feed the straw down till about 1/2 of just foam is left without needing to put the straw through. 3) Now for the duct tape. Make a small duct tape ball, and put that on the other end where no straw is poking out, and tape over it. Add 2-3 layers of strips of small duct tape around the sides. Test throw it to see if it needs more wieght. And now your done! |
| From left to right: Finished Throwing Dart, stefan, straw, long screw driver (-) |