 |
| Shotgun Barrel Attachment |
| After a long time of trying to aquire PVC, and finding the time to make this, I made this! This is the complete plans to build a Shotgun Barrel attachment to homemades guns, which can funtion to hold shotgun darts and darts! You will need the following: - Secret Strike Pocket Blaster Shell - PVC Pipe - A plastic clicky pen - Duct Tape - Plastic Bottle Cap 1) Okay, first off, cut a reasonable size from your PVC pipe. 6-7 will do fine. But make sure the plastic bottle cap will fit around the PVC! 2) Next, take the plastic pen apart. Keep the spring and its shell (the part you put your hand around duh). 3) Take your SSPB shell and duct tape it to the near end of the PVC, facing outwards like it would shoot the way the PVC end it stuck to is. Tape from bottum of SSPB shell and up to the top of the PVC in a loop several times till its firmly tight. 4) Cut the pen shell with scissors to the length of the SSPB standing upwards. Now take that piece of pen shell and duct tape it to the rim of the bottle cap. Kinda like a lolly pop. 5) Now take the spring and duct tape it or super glue it or stick on the PVC. Stick it on the left of it if you were pointing the barrel away from you. That left side. And at the end, leaving it to hang out a bit. 6) Now duct tape that other end thats sticking out of the spring and tape it to the bottle cap, leaving the pen part to point down. You dont want the bottle cap to be all the way on the PVC, cause that pen is like a trigger, and it'll be pulled to make the bottle cap move away from the PVC, then reset its self once let go. 7) Now you should have a SSPB attached to a PVC with a spring on the side attached to bottle cap with a pen taped to it. 8) Now make some shotgun darts and just load them in the front of the barrel. The bottle cap with protect them from slipping out, and when you want to shoot it, just pull at trigger! The trigger is suppose to move to the left, so it'll get out of the way of the barrel. Now get a cuppler er something so you can use the other unused end of the PVC to link it to the end of your homemade! If you require ANY help on this, please post either in the Shoutbox on the homepage, on the forums, or email me. |
 |
 |
 |
| Sorry for the bad pictures. It was taken with a webcam. But I hope this kinda guides you with making it. |
| As you can see, the cap and pen are detached from the spring. The spring is a big visible. Its the grey part poking out further on the barrel. Notice also that its on the left side. |