Ok, first you need:
- A Gun (primary)
- Duct Tape
- PVC
-Towel Foor Hangers
-PVC Glue
1) Ok, first off, lets make the rack. Get 4 pieces of PVC. Any size in width. Lets cut the vertical pieces into 15 inches. Now for the horizontal pieces. Cut those in any length you find suitable for your back. Cause this'll be the width, and you dont want it sticking to the sides out a lot. PVC Glue all the pieces like shown above. Make sure the horizontal pieces are spread far apart in a way your guns top surface touches.
2) Now with the rack done, lets get with the gun. The Supermaxx 3K above is just an example. Except I ment the gun to be facing the other way. So for start lets point the gun down, so that the handle of the gun is up, and when you want to grab your gun, you just reach over the top and grab the handle. Now just get 2 of those hangers you put at the top of your door. Usually substituted for a towel rack. These can be found at Home Depot, if not Bed, Bath and Beyond. Now cut off the end of the "square side". Where it hooks onto the door. Keep the round side though. now duct tape the door hangers so that their facing up, the round part that is. So that it can hook on to the rack. Keep the door hangers the same hieght with the horizontal PVC pipes, so that both bottum and top hangers hook on easily.
3) Not finished yet. We just need to add strap on the PVC so it can be a backpack! Just feed some sort of long material through the vertical pieces of PVC, on each end, so that you got your straps to go around your shoulder! YAY! Your done! You now made a backpack gun rack such as the one in Brute Force! |
