| Secret Strike Pocket Blaster Mod |
| I have finally done it! This is the SSPB mod ive been working on. Ive been thinking of ways to make this gun better, and so I came up with a lot of stuff, and cramed it all together. Now I came out with a great mod for your SSPB! |
| What you need to do this mod with is: -Electrical Tape -Saw (strong enough for PVC) -Scissors -PVC Glue -PVC pipe (2 inchs) -Pliers -Hot Glue -Mini screw driver (+) |
 |
| To do this here mod, you must first, take off that stupid cover. Next take the pliers, and twist out the rod in the orange barrel. Get your saw, and saw right in the spot where it changes its barrel size from small, to big (the third groove). Now when you saw down, pay attention: STOP RIGHT AT THE THIN "WALL" THAT SEPERATES THE BARREL FROM THE PUMP. Thats very important. I went ahead and went a bit through the pump. Big mistake. You can simply just wiggle the loose barrel out by now. Make sure when you place the PVC pipe on, it fits snug. Now PVC glue it down. |
 |
| Now, just take the electrical tape, and tape between where the PVC and the barrel stub connect. Now, with that useless barrel piece left, you can tape that at the top so it works like a mini scope, and a dart holder! Now, what Im about to mention, is by Sniper5000: At one point, your pump will just come out. If that happens, its good. cuase now, you can take the pump that fell out, and hot glue that hole on the bottom center of the pump. That helps out SO much, and increases the range! |
 |