| Gun Holsters |
| Making Gun Holsters for Nerf Guns are Easy as 1-2-3! What you need is: - Clothes Hanger - Duct Tape - Scissors - Any Gun for what the holster is for 1) Okay, bend the wire so that it is just one long wire. Its okay if theres bumps and stuff. 2) Shape it into a shape that will hold the gun in place, wiggle it around so you can make sure it holds right. Use your hand as "imaginary" Duct Tape. 3) When you done with the shape, duct tape the sides so that it will be easy to pull the gun in and out of the holster. Duct tape it so that its not thick! Leave a Gap so that when you stick the gun in, only the sides are taped and the hole for the barrel that has to go through will be open enough. 4) Now any wires shown bare, should be taped thin, so that its covered, but its not big and thick. 5) Add Tape going from one side of the holster to the other on the top so that when the gun goes in, the top of the gun will get more steadied. 6) If its not as steady as you think it should be, then tape it in areas that wont get in the way of when you pull the gun out, or in. 7) Add little duct tape rings in areas you would be able to reach easy, so you can grab ammo out of the rings. Im trying to make a way to make the holster onto a belt, so just wait for a while. |
 |
 |
 |
 |
| Above, is the holster with ammo in it. |
| Above, is the holster showing where the barrel goes through |
| Above is the holster from top view |