Materials:

1 large bead
1 colored prism, buy size that is compatible with bead
Thin ribbon
E-6000 glue

Directions:

Cut an 8" piece of ribbon & fold in half.
Thread the cut ends thru the hole in the bead.
Leave approx. 6" of the ribbon for the hanger
& pull the rest thru the bead.
Apply a small amount of glue to the tip of the prism.
Holding the ribbon up on each side of the bead
place the hole of the bead over the tip of the prism.
You can use a dab or 2 of hot glue around the edges
of the head to hold it in place while the E-6000 glue dries.
When the glue has dried pull off the dabs of glue.
Trim the cut ends of the ribbon & you are finished!!