| Performance Upgrades |
| This is the DreamSpeed intake that I installed. You get a noticeable amount of power from the intake. Intakes are now available from DreamSpeed. Just click on the picture. |
 |
| This is a picture of the Custom Car Grills underdrive pulley that replaced OEM crank pulley. I would say its good for 8whp. I feel it most on a downshift or when racing in 3rd gear. It works only for the 2.5l V6. |
 |
| Here is a picture of my rims, 17" Katana Shockers. I am currently using 225/45/Z17 tires. This is the closest size to stock. |
 |
| The DreamSpeed rear sway bar adds much needed performance to all Cloud Cars handling capabilities. It makes the suspension feel more like a race car than a family car. Simple lane changes are firmer and cornering is as easy a spreading butter. This is the best mod for the suspension. |
| This is the DreamSpeed raer strut tower. It retails for $70 and does a good job of eliminating body roll. A must have for sure. Click on the picture to order yours today. |
| I lowered my Stratus with Suspension Techniques springs. DreamSpeed sells the for Stratus, Cirrus, Breeze models. Click on the picture to go to their site. |
 |
| This is a picture of the tail end of my exhaust setup. The muffler is made by MaxSpeed and both of the tips are resonated to give a deeper tone, not the toybox sound. You can get them from DreamSpeed for $150 shipped. The piping was increased to 2.5" from the cat to the muffler and a Thrush glasspack was installed in place of the two resonators. |
 |
| This is the Thrush glasspack that I mentioned above. Its 2.5" on both the inlet and outlet. On the V6 only there is a resonator that looks similar to this one that was replaced. |
 |
 |
| I recently purchased a SuperChips ICON race chip. Its a piggy back system that advances timing and has an optional software option for your programming needs. My guess is that it produes about 10hp to the wheels. I'll have a dyno soon. |
 |
| I installed a B&M transmission cooler to prolong the life of the transmission. The 1st-2nd and 2nd-3rd shifts became smoother and the install is fairly easy. Just beware to check the hoses every month or so to make sure they are secure. |
| This a the throttle body that was bored by Proflow Designs. It provides a decent amount of power. There is more power available a lower RPMs due to the added airflow. This is one of the better mods for performance and ProFlow did an excellent job. |
 |
| The Accel wires are some of the best in the market. At 150 Ohms per foot, they have the lowest resistance of any wire tested for the V6 to date. The wires avaraged 270 ohms total in resistance. They were also inexpensive at $86 shipped. Click to order. |
 |
 |
| This is a picture of a custom front strut tower made by Stratusphere member Rezlo. It performs great and I recommend getting one if you can. |
| My newest mod is the Venom 1000 N2O kit. Retails for $650 at DreamSpeed. No further explanation required. |
 |
 |
| Just recently installed an MSD 6A ignition box. This is a picture of the Blaster 3 coil. So far the car runs and idles smoother and gas mileage has increased 1mpg-2mpg. The distributor cap needs to be modified to accept a tower. |
| This is a Ractive air filter. I have had it replaced because it was limiting air flow. This filter should be used for show only. |
 |
 |
 |