Futuba 9C programming for the OMP 540 Profile
My set up is pretty simple. I use the 3 position switch for my triple rates. I use them a little differntly than most people. Low rate i set up for normal flat spins and smoothflying. High rates I use for normal flying. EX....walls, paracutes, waterfalls, knife edge flight, climbing flat spins, blenders, etc....etc. The third position i use for harriers and elevators.

Now ofcourse dualrates and expo are on the seprate switchs but i also link the mixs to them. Low rate there is no mix or expo. The throws are set to do spins. The second rate is set to max out throws and flaperons added. I have about 25% flaperons dialed in. D/R= 130% EXPO=  -40% on ail....D/R=  140% EXPO=  -55% on elev.......D/R= 100% EXPO= -25% on rud....On the third rate everything is the same but i dialed in 20% static spoilers.
That really settles the plane down on elevators and harriers.

I use Du-bro standerd arms on the servos and rocket city ends on the surface. The biggest arm in the package I use on the elevator servo. The next size down I put on the rudder servo and the smallest arm I put on the ailron servo. I use rocket city ends on all surfaces and Z bends at the sevo.I have pics down below to show hook up of the servos.
Heres a picture of low rate.
And heres one of high rate
Elevator servo
Rudder servo linkage
Hosted by www.Geocities.ws

1