FT-411 Modification

     FT 411 OUT OF BAND MODIFICATIONS.
      ---------------------------------
 1) Open the front cover

 2) Locate the C.P.U. unit (it is located on the front cover ).

 3) Locate Jumpers 1,2,3 and 4 , These are the band setting Jumpers

 4) Jumpers No 1, 2 and 4 should be disconnected ,and Jumper No 3
 should be connected.

 5) Close the radio .

 6) Apply power to the radio and turn it on.  The display will
 initialize with memory No 1 flashing and the frequency display
 will show 1.000

 7) Now , adjust the display to the desired lowest receive
 frequency. When done ,press VFO. The memory CH will now
 show 2 flashing.

 8) Adjust the display to the desired highest receive frequency.
 When done press VFO. The memory CH will now show 3 flashing.

 9) Adjust the display to the desired lowest transmit frequency.
 When done ,press VFO. The memory CH will now show 4 flashing

 10) Now , adjust the display to the desired highest transmit
 frequency. When done ,press VFO. The rig is now set for your
 programed band on transmit and receive.

  COMMENTS
  -------
 1) After the rig was programmed to the band and you want to
 change it to other ranges you will have to open the rig again
 and disconnect Jumper No 3 then to apply power to the radio,
 turn it on again open it again ,connect Jumper No 3 back and
 repeat from steps 5.

 Any comment and other information would be appreciated.
 disclamer: I have not tested or verified the above,
 proceed at your own risk.
 WA2ISE
ft411.5

RECENTLY I SAW A MOD COME ACROSS THE SYSTEM ABOUT THE YAESU 411E PTT LOCK.
THE SAME MOD IS AVAILABLE ON THE 411. JUST TURN OFF THE RADIO. HOLD THE PTT
BUTTON AND THE #6 BUTTON WHILE TURNING ON THE RADIO. PRESS FM THEN 6.
PRESS FM THEN 6 AGAIN THE LOCK AND THE PTT ICON WILL NOW BE ON. THATS ALL THERE IS TO IT! TO TURN IT OFF JUST PRESS FM 6. ENJOY 73 DE BOB KB8GNF