CIRCLE MACHINE
To make this instrument you will need:
1 cardboard box
3 potentiometers (value unimportant
wire (guage unimportant but workable)
18 small, ceramic magnets (usually found at Radio Shack)
3 knobs
a piece of aluminum foil
1 plastic can lid
1.� Print out the gif of plate 1.
2.� Glue that to the top of the cardboard box.
3.� Punch holes for the stems of the potentiometers at the center points of the three calibrated circles at the base of the pattern.
4.� Punch two small holes at the edge of the large circle, where the lines from the calibrated circles meet it.
5.� Wire the three potentiometers to each other like the three circles.
6.� Attach a longer wire at each end of the series of potentiometers.
7.� Attach the potentiometers to the bottom of the box top so that the stems stick out through the calibrated circles.
8.� Put the end of each longer wire through the holes in the box top and lay them in the large cirlce.
9.� Cut out a circle of aluminum foil and glue it to the center of the large circle so that it contacts the two wires.
10.� Glue a magnet to each of the smaller outlying cirles around the larger one.
11.� Attach the knobs to the potentiometer stems.
To use this instrument:
1.� Place the witness of the target in the center of the foil circle.
2.� Tune the instrument for the rate for the target by laying the plastic cover next to the instrument and gently rubbing it with your thumb while turning each knob.� When you get a stick (and you will know it when you get it) that knob is properly tuned and you repeat the procedure with each knob until all three are tuned.
3.� Gaze intently at the witness and think what you wish to send to the target.� The combination of tuning and the magnetic vortex will significantly amplify your telepathic sendings.
