--------------------------------------------------------------------
NANO SCALE METHAMPHETAMINE CURBSHOT STYLE
--------------------------------------------------------------------
--------------------------------------------------------------------
I. Extraction
II. Reaction
III. Crystallization
--------------------------------------------------------------------

The ratios are based on your using red phosphorus from matchbooks
and iodine from tincture. DO NOT ADJUST RATIO. The reason is never
once while nano pondering had a failure or half reacted product, and
never yielded under 60%. So follow instructions and don't make any
adjustments. From start to finish takes swim 2 hours. Give yourself
2.5 hours. You will end up with at least 0.7gm of get your dick hard
meth.

Don't get me wrong, swim has seen his share of failures during his
adventures of cooking, but for some fucked up reason those were only
seen in much larger scale cooks. Swim has taught friends this nano
scale procedure because some people have a really hard time
understanding the mathematics of producing meth. Learning this way
will teach you the basics hands on. Ask any of the big boys:
methead, warlock, placebo, rhodium; fuck, there's a lot of them now.
Producing HIGH QUALITY meth fail safe and consistently is a skill
that takes 100% visual/observational skills and actually knowing
what is happening WHILE it is happening and knowing that fine line
of needed adjustments if things don't go as planned. That makes this
synth a good tool to exercise your observational skills and get you
clued in on what is going on. And most importantly, a fat bowl when
finished.

--------------------------------------------------------------------
I. Extraction
--------------------------------------------------------------------

MATERIALS:
1. 8oz denatured alcohol
2. 24ct pseudoephedrine pills 60mg
3. 12oz glass jar / lid.
4. 2 coffee filters /funnel
5. Corning/Pyrex plate
6. heat source (no open flame)

Crush your pills and put in 12oz glass jar. Add the denatured
alcohol and fit with lid. Shake jar hard a few minutes. Place jar
into freezer for 10 minutes. Shake again and return to freezer for
an additional 20 minutes. Your pseudoephedrine will be dissolved in
the alcohol while the waxes and fillers will settle to the bottom.
Carefully pour the top layer into a funnel with coffee filter and
onto a glass dish. Evaporate the alcohol (gentle heat and/or hair
dryer.) You should have around 1.5gm pseudoephedrine.

--------------------------------------------------------------------
II. Reaction
--------------------------------------------------------------------

MATERIALS:
1. test tubes (glass cigar tube works good)
2. 3in. balloon ( standard kids size water balloon)
3. black electrical tape
4. 2 soup cans (one filled with damp sand)
5. candle (buy the kind that sit in glass bowl)
6. pseudoephedrine / iodine / red phosphorus
7. small amount of peroxide (common household)
8. distilled water

Using 2 soup cans, one on top of the other, makes a perfect source
of heat to the moist sand. Construction is very simple: the lower
can has holes drilled throughout it for air supply for flame. Now
with candle lit in 1st can place 2nd can with sand right on top. The
sand will warm instantly and your ready to go.

You will be using:
1-1.5gm E
3gm I
2gm RP

Place your test tube in freezer 5 minutes before adding chemicals.
In the following order add: I, E, RP. Have your tape and balloon
ready to go. With a dropper add 4 drops of peroxide and place
balloon over test tube approx. 1cm. Tape balloon in place. Using your
finger to prevent anything from entering the balloon, shake the 3
reactants to mix well. The reaction will start, now place tube into
sand 2.5-3 inches and set timer for one hour. Exercise your
observational skills; take notes on what you see. After a handful
of runs at this soon you won't need to set a timer because you will
have schooled yourself and have your own tools (sign's) that
completion of the rxn is there. But for now go with 1 hour, no more
no less. Blow your candle out and let tube cool in sand for 15 min.
Take your now room temp. test tube and cut balloon off. Add 20ml
dh2o. With thumb over the hole, shake up and filter out the red (its
good to have a few test tubes clean and handy) by pouring liquid into
another test tube using small funnel and 1 coffee filter (saturate
filter with dh2o prior to using.) Now your left with a clear,
yellowish liquid.

--------------------------------------------------------------------
III. Crystallization
--------------------------------------------------------------------

MATERIALS:
1. Red Devil lye
2. charcoal lighter fluid
3. muriatic acid
4. dh2o

Add 8gm of lye to a clean test tube. Now add 20mL of dh2o and mix
well (use gloves if you shake tube using your finger as a stopper!)
then place in sand to cool.

Add 50mL lighter fluid to the tube with your yellow liquid. When
cool add the lye solution SLOWLY to the tube with the yellow liquid
and lighter fluid. Don't pour it in all at once, add splashes until
gone. Cover the hole and give it one good shake, release the
pressure and place in sand for approx. 15 minutes. Your lye will be
locked on the bottom which is fine. Pour off lighter fluid into a
clean test tube. Add 20mL dh2o, 4 drops of acid and shake hard.
Use an eye dropper to get the bottom layer, attaching aquarium
vacuum tubing to extend the length if needed. Pour this onto your
glass dish and evaporate. What remains after dh2o evaporates is pure
meth. Scrape crystals with razor and enjoy! That's all folks!

